CLUTCH SYSTEM
|
10-20 mm (3/8 - 13/16 in) |
|
CABLE END ADJUSTER |
|
|
Measure the clutch lever freeplay at the lever end. FREEPLAY: 10 - 20 mm (3/8 - 13/16 in)
Minor adjustments can be made with the cable end adjuster.
Turning the cable end adjuster in direction A will increase freeplay and turning it in direction В will decrease freeplay.
If the adjuster is threaded out near its limit and the correct freeplay cannot be reached, turn the adjuster in direction A until it seats lightly and then turn it out one turn in direction B.
Make the major adjustment with the in-line cable adjuster.
Major adjustments can be made with the in-line cable adjuster.
|
CABLE ADJUSTER |
|
|
Loosen the lock nut and turn the adjuster.
Tighten the lock nut.
If proper freeplay cannot be obtained using both procedures or the clutch slips during the test ride, disassemble and inspect the clutch (page 11-9).
|
BOLTS |
|
|
|
THROTTLE CABLE ENDS - * /1L Ш?'Ж' ”" |
Remove the dust cover and throttle housing bolts. Turn the handlebar to the right fully and remove the throttle housing from the handlebar.
Disconnect the throttle cable end from the throttle pipe.
|
It is not necessary to lubricate the entire cable. |
Thoroughly lubricate the cable ends with a commercially available cable lubricant.
If the throttle operation is not smooth, replace the cable.
Be sure the throttle returns freely from fully open to fully closed automatically, in all steering positions.
|
|
|
HOT START CABLE |
|
CABLE ENDS |
|
CLUTCH CABLE |
Turn the adjuster and remove the clutch cable. Disconnect the clutch cable upper end and hot start cable upper end from the levers.
|
It is not necessary to lubricate the entire cable |
Thoroughly lubricate the cable ends with a commercially available cable lubricant.
|
|
|
ADJUSTER |
If the clutch lever and hot start lever operation is not smooth, replace the cable.
