ANUAL SERVICE M

BEARING REPLACEMENT

Press the needle bearings out of the swingarm using the special tools and a hydraulic press.

TOOLS:

Driver

Attachment, 24 x 26 mm Pilot, 22 mm Attachment, 30 mm I. D.

Pack new needle bearings with grease.

Press a new needle bearing into the swingarm using the special tools and a hydraulic press as shown.

TOOLS:

Driver 07749-0010000

Attachment, 28 x 30 mm 07946-1870100

Pilot, 22 mm 07746-0041000

Apply grease to the thrust needle bearing rolling area and dust seal lips.

Install the following:

- Washers

- Thrust needle bearings

- Pivot collars

- Dust seals

- Side collars

Install the chain slider so its hole fits over the tab on the swingarm.

Clean and apply locking agent to the screw threads. Install and tighten the screws to the specified torque.

TORQUE: 4.2 N m (0.4 kgf-m, 3.1 Ibf ft)

INSTALLATION

Apply thin coat of grease to the swingarm pivot bolt sliding surface.

Install the swingarm onto the frame.

Install the swingarm pivot bolt through the frame and swingarm pivot.

Install the washer and swingarm pivot nut.

Tighten the swingarm pivot nut to the specified torque.

TORQUE: 88 N m (9.0 kgf m, 65 Ibf ft)

Apply oil to the shock arm nut threads and seating surface.

'05-'07: Install the shock arm bolt, nut and washer.

After '07: Install the shock arm bolt by aligning flat surfaces of the shock arm bolt and swingarm.

Tighten the nut to the specified torque.

TORQUE: 53 N m (5.4 kgf m, 39 Ibf ft)

Install the following:

- Drive chain (page 4-25)

- Collars ('05-'07)

- Chain guide slider

- Chain guide

Install and tighten the bolts and nuts to the specified torque.

TORQUE: 12 N m (1.2 kgf-m, 9 Ibf ft)

Do not twist the Install the rear brake caliper to the slide rail on the

brake hose, swingarm.