BEARING/MECHANICAL SEAL/OIL SEAL REPLACEMENT
|
BEARING REMOVER SET, 12 mm |
|
SEAL |
|
BEARING |
|
|
Remove the water pump shaft bearing using the special tools.
TOOLS:
|
07936-1660101 not available in U. S.A. 07741-0010201 07936-1660110 not available in U. S.A. 07936-1660120 not available in U. S.A. 07936-166010A 07936-3710100 07741-0010201 or 07936-371020A |
Bearing remover set, 12mm
- Remover weight
- Remover head, 12 mm
- Remover shaft
TOOLS, U. S.A. only:
Bearing remover, 12 mm Remover handle Remover weight
|
MECHANICAL SEAL |
|
|
Check the oil seal for damage or deterioration, replace it if necessary (page 7-12).
Remove the mechanical and oil seals from the right crankcase cover.
Apply grease to the oil seal lips.
install a new oil seal into the right crankcase as
shown.
|
|
|
MECHANICAL SEAL DRIVER |
|
Drive in a new mechanical seal using the special tools as shown. |
|
Be careful not to damage the mechanical seal lips. |
|
TOOLS: Driver Mechanical seal driver |
|
07749-0010000 07945-4150400 |
|
Apply grease to new mechanical seal lips. |
|
BEARING |
|
|
|
Drive in a new bearing into the right crankcase cover using the special tools as shown. |
|
Drive in a new bearing squarely with the marking side facing toward the inside of the right crankcase cover. |
|
TOOLS: Driver Attachment, 28 x 30 mm Pilot, 12mm |
|
07749-0010000 07946-1870100 07746-0040200 |
|
Apply oil to new oil seal lips. |
|
OIL SEAL £§? |
|
IMPELLER 12 N-m (1.2 kgf-m, 9 Ibf-ft) |
|
WATER PUMP COVER |
|
|
|
MECHANICAL SEAL WASHER |
|
SEALING WASHER O-RING ^ |
WATER PUMP SHAFT BEARING
Install the water pump shaft into the right crankcase cover.
Install the washer and impeller onto the water pump shaft.
|
|
WATER PUMP SHAFT RIGHT CRANKCASE COVER
|
IMPELLER |
Install the right crankcase cover (page 11-6). Tighten the impeller to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 Ibf ft)
|
DOWEL PIN |
Install a new O-ring onto the water pump cover. Install the dowel pin.
O-RING 5Й?
|
DRAIN BOLT/SEALING WASHER |
|
BOLTS |
Install the water pump cover and tighten the bolts securely.
Install the drain bolt and a new sealing washer. Tighten the drain bolt securely.
WATER PUMP COVER
Install a new O-ring into the water hose joint groove.
|
|
|
BOLTS |
|
WATER HOSE JOINT |
|
O-RING |
Install the water hose joint onto the water pump cover and tighten the bolts securely.
Fill the system with the recommended coolant and bleed the air (page 7-7).
|
|
