EuroSun2008-5

Test System Components

According to the standard ISO 9459-2, test procedures for characterizing the performance of solar domestic water heating systems operated without auxiliary boosting are established. A “black box” approach is adopted which involves no assumptions about the type of system under test; the procedures are therefore suitable for testing all types of systems, including forced circulation, thermosiphon, freon-charged and integrated collector-storage systems. The test system is applicable only to systems of 0.6 m3 of solar storage capacity or less.

image031

Fig.1. ISO9459-2 test system principal flowchart

The structure and flow charts of solar water heating test system is shown in the figure 1. The main components of test system include units as shown below, constant temperature tank, return tank, water heaters, cooling systems, water distributor, water collector, pumps, solenoid valves and other components. The instrumentations coincided with measurement requirements of ISO 9459-2 contain pyranometers, diffuse pyranometers, anemometers, flowmeters, PT-100 thermal resistance and data recorders. Pipe system in test system of solenoid valves and non return valves to control the direction of flow can be achieved with the open-cycle and closed cycle. And so, solar water heating test system can separately test daily system performance, the degree of mixing in the storage vessel during draw­off and the storage tank heat losses.

After repeated testing determined in design, now the test system is completed. Solar water heating test system is presented in Figure 2 as follows.

image032

Fig.2. Photo of the test system

EuroSun2008-5

Automatic Control System

The whole automation system is mainly divided into two parts: one part is the hardware equipments consisted of all kinds of devices used in the testing system; the other part …

The application of the regulations minimal solar collector area

Following the new regulations, a three bedrooms autonomous zone must have a minimal collector area of 4 m2 independently of the climate zone were is located. From the simulations results …

Measured sequences used for validation purposes

The comparison of experimental and calculated instantaneous power results, obtained after the different approaches presented in the previous section, is based on instantaneous efficiency measurements for a CPC collector (C …

Как с нами связаться:

Украина:
г.Александрия
тел./факс +38 05235  77193 Бухгалтерия
+38 050 512 11 94 — гл. инженер-менеджер (продажи всего оборудования)

+38 050 457 13 30 — Рашид - продажи новинок
e-mail: msd@msd.com.ua
Схема проезда к производственному офису:
Схема проезда к МСД

Партнеры МСД

Контакты для заказов шлакоблочного оборудования:

+38 096 992 9559 Инна (вайбер, вацап, телеграм)
Эл. почта: inna@msd.com.ua